Leaderboard

Modelled and uv'd these buds and case some time ago for a beats advertisement, initially i was provided with exported CAD data which unfortunately served as little more than a guide when remodelling, due to being too dense and too poorly topologised, was a tricky one for sure, mainly due to how particular beats are with representation of their product, little room for error here, even down to bevel diameter. Over all happy with the results. all other aspects created by Steve Choo/my active driveway. Steve did an amazing job putting this together all props to him for the finished product. link to his page below. ( will update this with some wireframes when i get the chance ! ) V https://www.myactivedriveway.com/#/apple-beats/-solo-buds/ beats_solo_buds (1080p).mp4

Really nice work!! Also like the other work on your web site. Good stuff! -John

Why is it essential to use a spline for attaching the teeth ? You can easily just make a selection of your points and clone the teeth there. You will need two selections and two cloners to orient the teeth opposite to each other

Very nice, thanks for sharing!